Organized Drag Racing and Autocross Drag racing and autocross discussions and questions. Techniques, tips, suggestions, and "what will I run?" questions.

first run new motor

Thread Tools
 
Search this Thread
 
Old 07-27-2004 | 07:01 PM
  #1  
automec's Avatar
Thread Starter
Member
 
Joined: Nov 2002
Posts: 390
Likes: 0
From: idaho falls id.
Car: 82 Z-28
Engine: 408
Transmission: TH-400
Axle/Gears: 4.11
first run new motor

well now that i had to sell the fogger to put the motor togeather again (3rd time this year) i finally got to a track again. went to anaconda montana eleavation 5200' but the denisty alt. was all the way up to 9400' ran a best of
1.78 60foot
8.06 1/8 mile
88.9 mph
i was discourged until i herd how high the corrected eleavation was .
where do you find the correction factors ? i know there out there . i'm hopeing to be in the high 11's in the 1/4 at a lower track

mike
Old 07-28-2004 | 10:02 AM
  #2  
five7kid's Avatar
Moderator
iTrader: (14)
 
Joined: Mar 2000
Posts: 43,169
Likes: 36
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
http://www.nhra.com/tech_specs/altitude.html

The bottom chart.

Note it only factors elevation, not density altitude.

This year has been relatively cool weather-wise for us, so we've had more runs in the 8xxx DA than 9xxx, which has been norm in summers past. I've seen it over 10,000' more than once.

Lowest DA I've ever run was 900' on a cool Sunday morning (7:09 a.m.) at the Div V ET finals in Topeka in 2002. That was our first and only time trial before eliminations - which started for Sportsman at 2:30 that afternoon - DA had climbed to the 1500' range by then.
Old 07-28-2004 | 08:25 PM
  #3  
automec's Avatar
Thread Starter
Member
 
Joined: Nov 2002
Posts: 390
Likes: 0
From: idaho falls id.
Car: 82 Z-28
Engine: 408
Transmission: TH-400
Axle/Gears: 4.11
thanks
i couldn't believe they actually list anaconda!
just correcting to sea level it ran a 7.61 let alone how HOT it was !
mike
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jhawkeye
Engine Swap
5
05-25-2022 06:33 PM
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM
Bradsaundry
TPI
7
08-12-2015 12:34 AM
Elliswon
LTX and LSX
4
08-10-2015 12:33 PM
squiggy2
TPI
4
08-09-2015 09:30 PM



Quick Reply: first run new motor



All times are GMT -5. The time now is 08:22 PM.