HELP WITH LS1 SWAP
01-23-2013, 04:05 PM
#1
Junior Member
Thread Starter
Join Date: Jun 2009
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
HELP WITH LS1 SWAP
I have a ? about putting a ls1 in my 91 camaro, i have a pa racing k member that had just reg small block mounts on it. where or who sells a kit that has both motor mounts and mounts that bolt on to my k member. whould like for it to be poly on block. and i think i would like to move the engine up an 1inch. so please if any info thanks
01-23-2013, 04:26 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,461
Received 1,839 Likes
on
1,399 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: HELP WITH LS1 SWAP
Trick question?
If I were in your shoes, my first phone call would be to PA Racing.
If I were in your shoes, my first phone call would be to PA Racing.
01-26-2013, 12:59 PM
#5
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,936
Likes: 0
Received 145 Likes
on
79 Posts
Car: 91 Trans Am
Engine: LSA
Transmission: T56 AWD
Axle/Gears: 8.8 4.10
Re: HELP WITH LS1 SWAP
The most common engine position uses 1" back from the common SBC adapter plates like these
If you're moving it up 1", then use the generic adapter plate that classic muscle cars use like these
So get generic SBC mounts for a 3rd gen and use the standard adapter plates
If you're moving it up 1", then use the generic adapter plate that classic muscle cars use like these
So get generic SBC mounts for a 3rd gen and use the standard adapter plates
Thread
Thread Starter
Forum
Replies
Last Post
