Stock Trans Cooler Lines
#1
Stock Trans Cooler Lines
Hey guys, the last thing I need to do before starting up my ls1/4L60E combo is attach my trans cooler lines....you're probably wondering why I didn't have them in the bay as I did the swap...and I'm asking myself the same thing lol. But in any case I'm here now with an engine and trans in the bay but no cooler lines. Is it possible to actually snake the stock cooler lines around into place or should I just lift the engine out a bit to do it? I tried a couple different routing paths last night with no luck, the lines would probably bend and break if I forced it.
If you have any recommendations or possibly pictures of your stock 700r4 cooling lines routed to your 4l60e that would be great to see!(i tried search multiple times) Or my other thought was switch to AN like others have done, which could look much nicer and be more manageable in the long run.
thanks!
If you have any recommendations or possibly pictures of your stock 700r4 cooling lines routed to your 4l60e that would be great to see!(i tried search multiple times) Or my other thought was switch to AN like others have done, which could look much nicer and be more manageable in the long run.
thanks!
#3
Re: Stock Trans Cooler Lines
ok I'll give it another shot, maybe jack the car up more so I have more room to work with! So I will go over the kmember kind of near the oil pan, and both lines will be routed UNDER the motor mounts correct? I wish I had my old pics of the 350 swap with nothing in the bay but the trans/trans cooler lines so I can see how they sat in relation to the mounts. Thanks!
#4
Supreme Member
iTrader: (10)
Join Date: Oct 2007
Location: Fl.
Posts: 1,881
Likes: 0
Received 2 Likes
on
2 Posts
Car: 83 Trans Am / 96 Jeep XJ
Engine: 355 / 4.0 I6
Transmission: TH350 / Auto
Axle/Gears: 3.23 10-bolt / 4wd
Re: Stock Trans Cooler Lines
Dont know if it helps you now, but I found this pic of my old 305, and you can see the stock trans cooler lines run under the mechanical fuel pump mounting block, I also remember they have a clip that bolts to the oil pan bolts that holds them against the block on an sbc.
#6
Re: Stock Trans Cooler Lines
for future reference, if anyone needs pics concerning installing stock 700r4 trans cooler lines on the 4l60e for an LS1 swap, i took some pictures and they are in this thread: https://www.thirdgen.org/forums/ltx-...l60e-85-a.html
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM