codyb_83

I have an LT1 350 with cast iron heads and an aluminum gm performance 4bbl intake manifold. this motor is complete from oil pan to air cleaner including starter and flexplate and the stock serpentine system, a 600cfm edelbrock carb(#1406) and stock HEI ignition. My car had a bare wire grounding out which burnt the alternator up so it will need replaced or rebuilt. I have about 2 or three extras i'd throw in that I believe are also bad but all are the 140 amp version.

Had it in my 91 camaro until blow-by from the valve cover breather became a problem. Other than that it still runs great!! Have no clue on the miles as my car doesnt have a working odometer. The previous owner said it only had 65,000 on it and i'm guessing i put on another 20k..


I am asking $900 for the complete setup.. obo.. I will try to get some pics up asap...

1bad92z

500.00 cash?

codyb_83

little low.. i will meet in the middle at $700 just to get it movin'..

mcgarnicle

iTrader: (14)

You have any interest in parting out? As in all the carburated swap parts (manifold, carb, distributor, timing cover and block off)?

codyb_83

gotta research some prices and ill let ya know.. but its looking like thats where its going...

mcgarnicle

iTrader: (14)

if you do I call dibs on the Carb setup

codyb_83

Havent had time to research any prices since my computer crapped out so i will take any offers..

parting out the complete motor
if you would like pics just let me know and i'll post em or send them to you..

codyb_83@yahoo.com if you'd like to contact me about anything

mc g. you got first call on the carb setup. not sure about the cover and block off tho.. i looked and didnt see any block off.. not sure if my cover had to have one.. or if i just didnt see it.

mcgarnicle

iTrader: (14)

Thanks Cb ,

What year is your engine? I know the 95-97 Lt's needed the blockoff plate but not sure about previous years. Also can you put some pics up of the intake, distributor, and timing cover? I'm thinking like $300 plus shipping? let me know what you think.

I don't suppose the engine is overbored? I'm looking for some .030 flattop pistons with 5.7 rods.

Ken.

codyb_83

price sounds good to me.. ill get the numbers and some pics up for you soon.. (sorry its takin so long but ive been having to use my ps3 to get online until my comp gets fixed)

im thinking it must be the older style though cuz i took the water pump off and looked for a plate but its just a one piece cover..

the lower end has never been touched so no luck on the pistons

i do have some std pistons for a stroker motor that are still new in the box if anybodies interested..

i would also like to sell the remaining parts of this motor if any body wants the longblock or shortblock.. still have the serpentine braket, ac comp, p/s pump, balancer, starter, flexplate, water pump, valvecovers, oil pan. make an offer..

mcgarnicle

iTrader: (14)

good deal man, I'm not in any hurry so take your time with the pics.

Thanks, Ken.

mcgarnicle

iTrader: (14)

Did you ever get any pics?

Hyper Tailz

iTrader: (1)

where are u located i would be intrested in the whole thing for 700 if ur close to miami. i would also like pics