Partial Floor Patch Panels????
#1
Partial Floor Patch Panels????
Anyone know of a source for partial floor patch panels for 3rd Gens?? I don't need or want the full floor panels but that is all I have seen for sale.
#2
Senior Member
Join Date: Mar 2007
Location: south of kansas city
Posts: 586
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 berlinetta 92rs gfx
Engine: 4 bolt 384 stroker
Transmission: th350 4000 stall manual/T brake
Axle/Gears: 87 iroc 9 bolt
Re: Partial Floor Patch Panels????
cookie sheets.
#5
Re: Partial Floor Patch Panels????
Nothing at Classic industries, already checked.
I know I can use sheet metal stock but was hoping to find actual formed parts that would be exact.
Cookie sheets? When the floor gets warm do you enjoy the smell of home baked????
I know I can use sheet metal stock but was hoping to find actual formed parts that would be exact.
Cookie sheets? When the floor gets warm do you enjoy the smell of home baked????
#6
Re: Partial Floor Patch Panels????
http://www.ecklerscamaro.com/product...0&dept_id=2206
Best bet if you want some random quarter of a floor pan your going to have to find a local place that fabricates panels. I have a place here by me in ohio that will fabricate small parts for you if you cut a section a bit bigger then what you want to patch and give them a rough idea of what the piece should look like. Anything smaller then a full floor pan you mine as well bring out the old cookie sheets.
Best bet if you want some random quarter of a floor pan your going to have to find a local place that fabricates panels. I have a place here by me in ohio that will fabricate small parts for you if you cut a section a bit bigger then what you want to patch and give them a rough idea of what the piece should look like. Anything smaller then a full floor pan you mine as well bring out the old cookie sheets.
Last edited by 88iroc52387; 04-25-2009 at 07:44 PM.
#7
Re: Partial Floor Patch Panels????
OK just to be clear, I hav alrady checked Eckler's, MidAmerica, Classic Industries, etc -those are all FULL floor pans.
I was hoping someone was making partials that would contour to the existing pans, the holes in mine are small - one the size of a dime, the second about 1/2" by 3" (yes they will get beigger when cut out), so looks like I will go with sheet metal stock. Can't believe no makes partials, oh well.
I was hoping someone was making partials that would contour to the existing pans, the holes in mine are small - one the size of a dime, the second about 1/2" by 3" (yes they will get beigger when cut out), so looks like I will go with sheet metal stock. Can't believe no makes partials, oh well.
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
3
09-17-2015 03:38 PM