400 one piece rear main seal crank
#1
Junior Member
Thread Starter
Join Date: Nov 2001
Location: arlington. tex
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
400 one piece rear main seal crank
who makes a one piece seal 400 crank for a stroker, and what kind of prices am i looking at, thanx for the info
#2
SCAT and Eagle both make one. That is if your looking to put it into a 350 block(383). Look to spend around $300.00 for a cast unit. Forged can be in the $400-$600 range. This was last years prices....it could be more or less now.
------------------
TABLESAWS SUCK!!
------------------
TABLESAWS SUCK!!
#3
Scat is cast steel I believe. Stronger than factory cast iron 400 cranks but not as strong as all out forged crank.
------------------
-Tas
'89 Formula WS-6 made in Van Nuys, CA, U.S.A.
305, TBI, 700R4, P.A.W. 14x3 open element with K&N, Milodon 160* thermo, functional Formula hood, cross-flow Flowmaster, '99z28 rear pipes and tips, Hooker 1-5/8" 50 state legal headers, Dynomax 3" I pipe (PN 44063 and 43248)
Super GRK_Taz World
F-Body Dual Exaust
EFI & Intake Options
------------------
-Tas
'89 Formula WS-6 made in Van Nuys, CA, U.S.A.
305, TBI, 700R4, P.A.W. 14x3 open element with K&N, Milodon 160* thermo, functional Formula hood, cross-flow Flowmaster, '99z28 rear pipes and tips, Hooker 1-5/8" 50 state legal headers, Dynomax 3" I pipe (PN 44063 and 43248)
Super GRK_Taz World
F-Body Dual Exaust
EFI & Intake Options
#4
Yep, I have the SCAT 9000 unit(2 piece seal). Building a 406(400+0.30) and decided to just go ahead and replace the factory crank. It had some bad spots and would have had to been welded back up. I don't think so.....
------------------
TABLESAWS SUCK!!
[This message has been edited by 93ND500 (edited December 13, 2001).]
------------------
TABLESAWS SUCK!!
[This message has been edited by 93ND500 (edited December 13, 2001).]
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM