help lt1 ecm programming
#1
Junior Member
Thread Starter
Join Date: Jan 2007
Location: Houston, Tx
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 firebird
Engine: swapping lt1
Transmission: 700r4
help lt1 ecm programming
any body in the houston area know a place to program an lt1 ecm. I am almost done with my swap into a 84 firebird, but need the ecm programmed to remove the vats and emissons
#3
swap
Im doing the same swap, I have a LT1 with elderbrock preformer heads and cam, I have not startd doing the sweap yet but i was wondering how hard was your wiring harness. did you run into probelms, and are you using teh ECM from the 87 or a ECM for a LT1? I have a ECM out of a 97 z28 and was gonna ust that....thansk for any info you can help me with, Im in San antonio.....
http://cgi.ebay.com/ebaymotors/ws/eB...4490503&rd=1,1
not sure how relayable they are but you can look into them.....
http://cgi.ebay.com/ebaymotors/ws/eB...4490503&rd=1,1
not sure how relayable they are but you can look into them.....
#4
Junior Member
Thread Starter
Join Date: Jan 2007
Location: Houston, Tx
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 firebird
Engine: swapping lt1
Transmission: 700r4
programming answers
the swap is easy the only hard thing to do is drilling a new hole for the passanger motor mount. i got the wire harness from currentperformance.com they made me a closed loop system that connects the ecm to the motor and allows it to run with out any major wireing just connect 3 wires crank signal, 12 volt power on run and start and the fuel pump wire. it cost me $550 but they can make one for you if you have an old harness for about $375. as for the programming i found some software for sale called lt1 edit, and i am going to buy that. if the motor is a 97 than it will work but if it is not than you have to program that ecm
Last edited by jrs84ta; 02-01-2007 at 08:39 PM. Reason: for got to add something
Thread
Thread Starter
Forum
Replies
Last Post
88SS6SPEED
Engine/Drivetrain/Suspension Parts for Sale
7
11-11-2015 07:05 AM
84, antonio, ecm, houston, lt1, lt1programing, programing, programming, reprograming, reprogramming, san, swap, tx