got me a 383 crank
03-25-2006, 09:41 AM
#1
Junior Member
Thread Starter
Join Date: Feb 2005
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
got me a 383 crank
whats up guys.site looks good.Im swappin in a 350 block in my 1990 camaro.the block is a 350 4 bolt-main rebuilding.I got a eagle 383 crank.Part number-ESP-103503750 Eagle Cast Steel Crankshafts.I was wondering if any one would know what i would have to do to the engine block to get this to work?Any info would be greatly appriciated.I know imma have to take this to a machine shop,but what should be done?Thanx.
03-26-2006, 12:48 PM
#2
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
you may have to clearance the oil pan rails, and another part of the block. you may need to grind down the bolt heads on your conn rods.
Bolt it into your block, and rotate it and check clearance. .060" on everything is needed, if you don't have that, mark it with a sharpie, then grind it down.
Bolt it into your block, and rotate it and check clearance. .060" on everything is needed, if you don't have that, mark it with a sharpie, then grind it down.
Thread
Thread Starter
Forum
Replies
Last Post
gixxer92
Engine Swap
33
04-12-2022 12:09 AM
UltRoadWarrior9
Tech / General Engine
336
04-28-2020 10:39 PM
