Found LT1/LT4 hose quick disconnects to AN
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2002
Location: Idaho Falls
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Trans Am
Engine: LTX
Transmission: T56
Axle/Gears: 3.42 strengthed 7.5 inch
Found LT1/LT4 hose quick disconnects to AN
For my LT1 swap I am running braided fuel lines.. after searching all over the place I found some quick disconnects that plug into the factory fuel rails but have 6AN connectors on them.. It was hard to find these so I figured I would share where they can be found..
Pure Choice Motorsports in AZ, performanceplumbing.com
Not too expensive.. this company is where street and performance gets theirs but marks up by 100%..
This is not an ad.. I just wanted to pass on the knowledge..
Pure Choice Motorsports in AZ, performanceplumbing.com
Not too expensive.. this company is where street and performance gets theirs but marks up by 100%..
This is not an ad.. I just wanted to pass on the knowledge..
#2
Junior Member
Join Date: Oct 2002
Location: WV
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Camaro RS
Engine: 96 LT1
Transmission: 4L60E
Strange, hehe, I was about to post the very same info. I purchased my LT1 fuel rail adapters and hose from them yesterday. I also let them know about the Earls 9894DBH/J's because they carried no adapter for the metal lines on the wheel well. He was very pleased that I gave him this info because they do carry a TPI fuel line kit but it contained compression fittings that you had to put on yourself. With these adapters it will make there kit plug and play for TPI users.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM