mult68

iTrader: (1)

Looking at which crank I should get for my 383. I have a 350 4-Bolt block...will be using 4340 forged rods, SRP forged pistons....Im not sure if I should go with a Scat 9000 crank...or a 4340 forged crank. I will probably pushing 450-500 horsepower....keeping it under 6500rpm. I am also planning on running a 150-200hp shot of nitrous. I want the engine to survive...but I'd rather put my money else where if the crank will be strong enough for my setup. What do you guys think?

ede

i'd buy a forged crank but i wouldn't buy anything from scat if i could help it.

Daz

iTrader: (1)

If you do dont use a Fluidampr/Streetdampr on it or this will happen



3700lb car running high 12's..As you can see the block broke before the crank..

Daz

mult68

iTrader: (1)

ouch...umm..maybe i will get the forged.

DTL504

iTrader: (1)

Daz
was this a Scat Crank, I was thinking about a Scat 9000 for my SBC 400 that will have about 450-500 hp/tq. i read wgere David Vizard was using these same cranks in his motors.

Z_Ghost

What ede said.

If I had seen this I would have thumped you today.

mult68

iTrader: (1)

haha phil...didnt know you ever read these forums....cool meet today huh?

Z_Ghost

Good way to learn lots of stuff about thirdgens and cars in general, I read almost all the boards here.


It was a great turn out, lots of thiregens on a cold day.

Daz

iTrader: (1)

Scat9000..One piece rear seal,external balanced

daz

DTL504

iTrader: (1)

I guess I will be buying a Eagle Forge Rotating Assembly.
Thanks for the info Daz.
David

badgta

iTrader: (4)

dude if ya do go with scat, then make sure to look it over real close, and check for missed burrs in the oiling holes in the throws.... they costed me a 5000 engine, well a rebuild atleast.....

wesilva

iTrader: (35)

Wow! This is the first I have heard of people unhappy with Scat products. What is the problem? Quality control?

badgta

iTrader: (4)

it was burrs..... if you have say ever grinded somthing, and you still have hose peices of metal that is still part of what you grinded but readt to come off......

i washed it down and everything, but they just didn't dislodge.....

i called brian at scat and he said it was my resoncibility for not seeing it and i should have sent it back, i told him it shouldn't be the coustermers responcibility to have to look over their work and he ought to be ashamed of himself.....

phil at flatlander told be it was scats fault and he would pay to have the crank turned and send me new bearings......

i'd get one from them again if i had to, i guess i was trying to just drive home about checking and washing everything down to it's at a point where you can eat of it... this way you know it's right!