[Sold] SBC Small Block Chevy 1.5 Lunati Roller Rockers
08-04-2017, 01:31 PM
#1
Supreme Member
Thread Starter
iTrader: (7)
Join Date: Jul 2002
Location: Chicago
Posts: 1,948
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1989 Camaro IROC-Z
Engine: L98 350 TPI
Transmission: Built TH-700 R4 (Vilgilante 2800)
Axle/Gears: 9 bolt w/ PBR's
SBC Small Block Chevy 1.5 Lunati Roller Rockers
For sale is a set of Lunati aluminum 1.5 roller rockers. These are designed to fit SBC small block chevy heads and are made for 3/8" rocker stud. These roller rockers were taken out of a engine that was built for my friends car circa 2004 and have approximately 2000 miles on them. There is some wear on the bottom of all of the rockers and there is some rubbing on the inside of the rockers where the adjusting nut once sat due to the stud girdle that was used when this engine was running. Over all there are in great shape ready to go into your engine. Roller rockers adjusting nuts not included due these rockers being run with a girdle that is not included.
$150 shipped OBO
$150 shipped OBO
Last edited by gearhead0384; 08-11-2017 at 03:05 PM.
08-11-2017, 03:05 PM
#2
Supreme Member
Thread Starter
iTrader: (7)
Join Date: Jul 2002
Location: Chicago
Posts: 1,948
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1989 Camaro IROC-Z
Engine: L98 350 TPI
Transmission: Built TH-700 R4 (Vilgilante 2800)
Axle/Gears: 9 bolt w/ PBR's
Re: SBC Small Block Chevy 1.5 Lunati Roller Rockers
SOLD