[NJ] Gen 1 Machined 350 Block
07-17-2011, 10:58 PM
#1
Supreme Member
Thread Starter
Join Date: Mar 2009
Location: Sussex County, NJ
Posts: 1,402
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1994 Z28
Engine: 355 LT1
Transmission: T56
Axle/Gears: 3.42
Gen 1 Machined 350 Block
I sold my IROC and moved onto LT1 f-bodies. I no longer have a use for this block. I had it at the machine shop last year.
Since the machine work it has not been fired up. I did have it assembled on a stand but sold the bottom end.
Bored .040" or .060" (I have to check with my micrometer), splayed to 4 bolt, milled to zero deck, boiled and magnafluxed. It would make for a good street/strip 355/358 or can be stroked to a 383/388. None roller block, casting came up as an early 70's camaro block.
$500 OBO. It's just sitting in my garage. Interested in trading for an LT1 motor, or other LT1/T56 parts. Don't be afraid to shoot me an offer.
Since the machine work it has not been fired up. I did have it assembled on a stand but sold the bottom end.
Bored .040" or .060" (I have to check with my micrometer), splayed to 4 bolt, milled to zero deck, boiled and magnafluxed. It would make for a good street/strip 355/358 or can be stroked to a 383/388. None roller block, casting came up as an early 70's camaro block.
$500 OBO. It's just sitting in my garage. Interested in trading for an LT1 motor, or other LT1/T56 parts. Don't be afraid to shoot me an offer.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
