My parts inventory has spiraled out of control so its time to sell some of this stuff.

-1985 TPI intake (9th injector) $100 includes shipping up to $20 - SOLD
-Firebird/Trans Am TPI air intake tube ( I have 2) $15 Shipped each - SOLD
-Accel HEI Super Coil (PN: 140003) $20 Shipped - SOLD

 

- SBC Gear Reduction Starter - DAMAGED DRIVE GEAR - caused the starter to grind on the flexplate every once in a while, but it still works, you may be able to replace the drive gear. $20 shipped
- Set of SBC V-Belt pulleys (Crank, Water pump, Alternator) $15 Shipped - SOLD
- Alternator (worked the last time it was used) $15 Shipped

 

- A.I.R pump pulley (6 rib) $5 Shipped -Scrapped-
- Misc. Carburetor throttle cable brackets $5 Shipped -Scrapped-
- Power Steering Pump (Small Diameter pulley) I don't know if this is any good or not but consider it a core $10 Shipped -Scrapped-

 

- Weiand Supercharger Pulley (Crankshaft) $100 Shipped OBO
- V-Belt Pulleys (Crank & Water Pump) $10 Shipped - SOLD

If you don't see it here, I might have it. I have a ton of parts I still don't have images of. Just ask and I'll try and dig it up.

All prices have some wiggle room especially if your close enough to pick them up, But I have some of this stuff so cheap I may not be able to ship it for what I'm asking.

Thanks for looking, and all parts carry what I'm gonna call a warranty. If it doesn't work, or is broken, or whatever, I'll ship out another one if I have it or refund your money.

 

do u have a carb'd sbc intake manifold for a 1987 and up?

 

Sorry kent624, I don't have one of those.

 

-Remanufactured firebird MAF. Bosch sensor with a made in Canada label. I can't read the part number or the name of the remanufacturer. $50 shipped - Sale pending

 

still got the tpi?

 

yeah, I still have it. The one pictured is off an 85. I also have a very nice one off an 86 and one off a 91. All 5.0L set-ups.

 

if ur selling the one off the 91 camaro tpi ill take it any picks ?

 

I'll post some pics of the 91 intake up here soon. Its still currently attached to the engine.

 

ok let me know if its 91 i want it

 

It include the sensors?

 

What sensors do you need? I'll see what I can dig up. I should have multiples of all the sensors except for MAF's

 

- 91 TPI intake - SOLD
91 305ci SBC - engine has 160,000 miles on it. I just removed the intake manifold last night and the engine has quite a bit of sludge buildup. It did run but I would tear it down and clean/inspect before running it. $50 OBO Shipping = expensive

 

- 4-bolt main SBC block. currently .030 over. Will need to be honed at the very least to clean up some surface rust. More than likely will need to be bored out another .030. Good High nickel content block (note the 010 and 020 castings in the timing chain area. $100 Shipping = expensive

 

sold i want it !!!

 

I'll get working on removing it from the engine tonight. Let me know everything you need. Sensors? Wiring? ect.

 

u tell me whats included ?

 

1BADZ28SD - you have a PM

 

so lucky...i need a 90-92 tpi. let me now if you get anymore? ill need comp/harness/everything to go from tbi to tpi, with cruise control if that makes a diffence.

 

pm replay

 

DARKmj16 - I do still have the harness, ECM, distributor for the 91 TPI setup. I'll make you a real good deal. Otherwise this stuff will be headed to the scrap bin.

 

shot me a price and ill check around see if i can get the rest for a good deal.

 

PM Sent ------->

 

Make an offer on any of these parts, what doesn't sell is headed to the scrap yard.

check out my for sale album here
https://picasaweb.google.com/cmcracer20/PartsForSale#

 

hey i will buy you the other intake if u want to sell it to me just make sure on the price with shipping