FIRDBIRD/CAMARO 82-92 PARTS..HUGE SELECTION

there are a ton of parts i have for sale. those who have bought something from me know how much i have.
doors, complete cars, interiors, seats, misc parts, 16 complete sets of tires, ground effects complete, alot of hard to find items.

this is my email address

wwestg@hotmail.com


913-406-7315

if there is anything from big items or just a few little things give me a call i mught have that hard to find part. thanks

305 complete tbi has all frt serpetine belt set up. still in the car with everything there. can still start. $200
have a 5speed complete if you want to drive you can....$450 thats with everything for the swap shifter, tranny, clutch, pedals, everything.
grey interior out of 88 firebird $100 obo
center console for firebird $140 with good console lid
radio pod $50
cd player $40 have 2 of them
overhead consoles for camaro and firebird
hoods $50 -$100
fenders $50
complete interior camaro....its everything including seats...grey $175
i have 16 complete sets of rims...15", 16", and some 17" chrome irocs....call for prices. prices vary from size or if they have tires on them.
4th gen center console...$65
center consoles camaro complete top and bottom $175
shifters, cables, no part too small or too big
radiator cover
complete t5 setup has less than 5000k on it, pedals, trans, b&m short throw, dual center force clutch brand new, aluminum fly wheel, and mini starter for this fly wheel $900
tpi heads, motors 305s and 350s
frt clips
8113 corvette aluminum heads with new roller lifters, rockers, and push rods recently been to the machine shop $600
drive shafts
complete grey seat belts
door panels,
hatch motor $45
camaro frt clip $150 i have 3 to choose from.
sway bars $30
i have 8 sets of seats...call for prices.
i have motors, trannies, heads, all sorts of stuff
2 tuned port injection complete systems. with harness and computer also a few parts
computers
have some after market SVO 30 lb injectors
doors off of a 90 firebird. all power with glass. $75 apiece. no rust at all. were bought in california and brought here to ks black/red
misc gauges, trim, t top trim, headliner, speaker covers plastic, shifters, cables, kick down cables, intakes, carbs, headers, flomaster exhaust,
full set of gauges carbon fiber autometer...brand new $600-- sell for $350
Dakota digital dash and cover-with all sending units-still in boxes...cast over $600 new sell for $300 with senders
17' chrome irocs...brand new cost over $1200 new--sell for $550,
2 gta hoods 91 and are black
front 88 transam bumper cover and full ground effects. in great shape for everything $400 seperate call for prices
i also have a 88 z28 camaro thats complete without motor and trans has subframe connectors welded in already. really clean. not all rusted out. floor pans are solid and has complete interior in great shape....$650 obo

if there is anything that is not listed give me an email or a call and i will get back to you as soon as possible. thanks

AND TONS MORE

rims and tires...sale this week only $200 for a set...i have 8 sets of rims...call for more info
interior peices marked down 10%
the more you buy the better deal you receive

wanting to sell some of the bigger things soon. come with all offers cant hurt to try

 

also have

frt tubular cross member just the cross member
arc is the name on it. $200

two garrett turbos will get the numbers on here soon. $400 for the set

have more to post if you need pics email me. i have most of them on my computer. u need any additional one just ask. thanks

 

pics of the tubular crossmember?

 

PM sent...

 

i need emails to send pics. just leave em and i will get them up. i will have some pics up tonight

 

some pics will be on tonight.

if there is anything that is not listed please feel free to ask. we are talking over 10 years of 3rd gen passion. lots of performance and stock stuff.

need email address for specific pics. thanks

 

here are some pics

 

more

 

more pics

 

all pms replied. more pics

 

more

$3500 for a 355
here s the info

Ever wanted 420 hp and 415 lbs/ft of torque from a 355 cubic in small block chevy with 9.5:1 compression? This is an exact duplicate of the dyno test page for the 7101 power package. This is a 4 bolt main, uses edelbrock preformer rpm camshaft and matching hydraulic lifters..which at 0.050-inch tappet lifts are 234 degrees on the intake and 244 in the exhaust. Valve lift on the intake is 0.488 inch and exhaust lift is 0.510- inch. The edelbrock performer rpm aluminum heads have 2.02 in intake and 1.60 in on the exhaust. Everything that is listed is brand new and all assembled. This is just sitting in my garage. Never been started. Have all receipts.


Comp cams high energy push rods 29.95
Speed pro file fit piston rings 89.95
Summit roller rockers 159.50
Block 275.00
Balance and install 120.00
Bore and hone 120.00
Balancer earl 84.23
Flywheel 46.75
Crank kit 5.7 175.00
Balance v-8 225.00
Assemble 60.00
Moly race rings 136.06
Gasket kit 39.06
Heads studs ch sb 164.31
Pushrods 44.79
Rpm edelbrock intake #7101 124.95
Edelbrock camshaft kit #7102 137.95
Edelbrock perf. rpm heads #6073 931.00
Edelbrock perf 750 #1407 219.95
Edelbrock timing chain 45.95
Summit pistons trw .030 367.60
Head gasket perma torque #1003 29.95
Headman headers #520-2242 386.99

This comes to over $4000 not including the 7 quart pan, the march pullys serpentine set up, water pump it came to over 8,000 dollars after adding all these accesories. thats it. straight to the point come with
Its your for $3500. Never been started and will come complete with wires, distributor, coil, and starter.
Call 913-406-7315 or wwestg@hotmail.com

 

I may be interested in the lambo hinges. $150? Also are they bolt in or weld in? Thanks

 

i am in need of a black headliner trim piece....the one in the back that goes from speaker to speaker and covers the rear of the headliner..

 

84 cra

the lambo hinges are heavy duty. they cost my over $650 brand new. i bought them and they have been sitting for almost 2 years. they come with 4 gas struts. these arent cheap one. id take $300 shipped. it will probably cost me over $30 to ship in the states

funk
i ll check tonight and if i have one $35 shipped.

 

most prices i have listed are shipped. i think my prices are about right. you can make an offer but please dont make it rediculiously low. cause you probably know the answer. lets make a deal

 

I am interested in "2" of these---

17' chrome irocs...brand new cost over $1200 new--sell for $550,

May be someone else here would want the other "2"?

Thanks,
Dave

 

How much for the B&M Shifter?
Is it for a 3 or 4 speed auto?

Thanks,
Dave

 

Want to check shipping of k member to 21703 ? also have a business address if it would be less expensive at all, have cash in hand if it's still avail.

email is bflee87@gmail.com thanks

-brad

 

is that the k member or the transmission crossmember ? looks like tubular k lol

 

i need ur address so i can get a shipping quote for the tubular engine cross member.

the shifter is for a 4 speed 700r4 automatic lets do $125 shipped

 

Im curious about the 5speed.. what kind of tranny is it? problems? miles? does it fit up to the 5.7?

 

the tranny will fit any small block chevy. it wil come with everything will need to do the entire swap
its in a car right now so u can drive it if u want. completely stock set up

 

Do you have a 5 speed shift plate to fit the 85-92 firebirds? If so, How much shipped to 58258?

Thanks,
Ryan

 

no shifter plate it was broken.

all pms replied to

 

do you have a lower shift boot for a t5? if so how much shipped to 10930?
thanks

 

how much for that msd distributor and do you have any eibach springs

 

d you still have the b&m shifter, tubular k member and the gauges? if so what can we do for that shipped 32907

 

Also are you selling the short shifter and dual center force clutch kit

 

If you want to separate, how much for the March serpentine kit?
Thanks, Clint

 

Would you happen to have an egr control valve that will fit an '89 GTA?

Thanks,
Phoenix

 

john msd dist $150

lillis email sent

short throw shifter and dual center force clutch plate disc and aluminum flywheel with starter $775 shipped

egr valve...cna you tell me more about the part number., want to make sure i get you the right thing. thanks


all pms replied

 

everything update and up to date. can still make offers if you want

 

I am interested in the Dakota dash if it is still avail. I trust the letters are red from the color of the LEDs. I am also interested in an A-pilar two or three gauge pod (the whole pilar one, not the add- on pod).

 

How much for just the short throw shifter?

 

Would you happen to have a set of fog lights and a wonder bar?

 

dakota digital dash is still available. it is red letters i can send more pics if you want. i have a ton.

hurst shifter is gone.

i have a complete frt bmper i ll let go for $250 shipped. has the lights, emblem and support. off a 88 transam no rips or tears. thanks

 

Do you have a 1228746 ECM by any chance??

I'm looking for a tbi 350 auto prom for it too.

 

Need a complete rear end. Prefer posi, but will take what I can get.
Also fuel tank sending unit.

 

sorry guys dont have a rearend or fuel sending unit. thanks

 

sold alot but there is still some stuff available if you are interested in any of it let me know. thanks

 

how much do you want for the valve covers just one set also do you still have the chrome iroc wheels and digital dash

 

still have the chrome irocs, digital dash, and the valve covers.

which set are you interested in ...you could always call
913-406-7315

 

I had to leave the country for a few days. I am still interested in the Dakota Dash if you have it.

 

yeah i still have it if you are wanting it, check out the pics. if you want it i can ship it for $300 shipped. give me your address and i will send it after you pay. love paypal but will take a certified cashier check, but you will have to wait until the check clears. here is my number
913-406-7315

 

what color are the seats?

 

'89 IROC fog light brackets?

 

hey do you still have that turbo setup?

 

your add mentoned headers but didnt specify whether they are LT or shorty or what brand, if you still have them.what about a set of manifolds from a tpi gta or iroc(mine on my gta are bad shape) shipped to 75119, Thanks

 

pic of the 4th gen center console, good grey carpet and headliner poss black if in good condition& how much? do u have a power bulge hood please email to rongsays@aol.com

 

Any cheap 350 TPI engine?