nelapse

iTrader: (17)

I have a set of Aluminum Vette heads for trade. #128's
They have angled plugs and square bore ports. These are center bolt heads.

I am looking to trade my aluminum heads for another set of heads.

These heads only have 30k miles on them and I will get pictures up tomorrow.

They have bolt in studs, and are very clean. 54cc Chambers.

I will take any decent iron head, but would perfer a centerbolt style and that can accept at least .525 lift on the springs. Let me know what you have.

jh_shady01

iTrader: (2)

I'll trade you a set of l-98 iron heads, they have about 6500 miles on them since rebuild. Where are you located? Why are you wanting to get rid of these?

Bowtiesniper

Umm, unless you take Shady's offer, I can offer you about the same deal, and maybe throw in a few extras to sweeten the deal (valvetrain, new GM parts, etc.)

lt1srule

hmm aluminum for iron .Whats the catch..

nelapse

iTrader: (17)

There is no catch, unless you consider the catching being I want the iron heads to handle up to or more than .525 lift. If it does not handle that much I am not interested.

One more thing. The heads are on my DD, so I need your heads first to swap it in and then I will send mine.

I perfer centerbolts, Vortec is a plus, but if it does not handle .525 lift I am not interested. Also, I will check the clearances before I send my heads out to make sure I did not get duped.

lt1srule

Just upgrade your springs ..There for no need to take them off..

nelapse

iTrader: (17)

I was thinking that, but I do not really want aluminum.

Upgrading the springs are the cheapest route, but I am not sure if that is what I want. I rather have vortec.

lt1srule

i see .