onebinky

iTrader: (1)

I have my homemade EFI project up for sale. The intake is an edelbrock vic jr, with ross machine injector bungs welded in vertical. The welding isn't perfect on the inside of the port, so I used high temp metal epoxy to smooth the port wall. I'll include the throttle body with the manifold. It's a twin blade holley 690 cfm wetflow that has been modified to dryflow. $75 for the manifold and TB.

I also have some edelbrock fuel rails. If I remember right, the ID is 9/16". I'll include the -AN line and fittings that are shown in the pics. $25.

I also have a Mallory high pressure fuel regulator 30-100psi, still attached to some -6an and -8an stainless braided line. $50.

It has been sitting for about a year, and needs to be cleaned up. I would like to sell this all together, but will seperate it if I have to. $150 for all this is a pretty good deal.

Here's what this stuff goes for new:
Manifold $225
TB $360
Rails $80
regulator $100
Stainless line $100+
Fittings $100+ Mix of aeroquip, earl's, and summit's house brand.

onebinky

iTrader: (1)

more pics

onebinky

iTrader: (1)

more

midniteplowboyy

iTrader: (1)

Is that $150 shipped to 75559? How well did it run, everything usable condition?

Do you take Paypal?

Thanks,

onebinky

iTrader: (1)

sorry for the delay in response, I didn't recieve any email notification.

It ran great, but it was to short of a runner length for my little 305. It lacked torque down low, but took off like crazy above 3k. Many others have ran similar setups on 350+ cui engines with great success. Everything is usable.

$150 for everything, and I'll split shipping. Let me know.

midniteplowboyy

iTrader: (1)

Ok, sounds good. PM sent.

Thanks,

midniteplowboyy

iTrader: (1)

Paypal and PM sent.

Thanks,

onebinky

iTrader: (1)

Sold!

Thanks Midnite