Need help with wiring
#1
Junior Member
Thread Starter
Join Date: Feb 2014
Location: Twin Falls, ID
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Camaro
Engine: 355 sbc
Transmission: 700r4
Axle/Gears: Moser Rear with 4.11
Need help with wiring
I had recently bought a 85 camaro with a 355 swap, but the previous owner seemed to have completely half assed everything. The wiring is daisey chained and split. Theres no organization what so ever, pieces of it are showing bare wire, its just an absolute mess. He had the wiring so messed up that it melted the positive clamp for the wires to connect to the battery. This is my daily driver, and Im on a tight budget, so I was just thinking if there was a quick and easy(ish) solution? Is there a kit, or a wiring harness that I could get that would make it a lot easier to rewire this mess.
#3
Junior Member
Thread Starter
Join Date: Feb 2014
Location: Twin Falls, ID
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Camaro
Engine: 355 sbc
Transmission: 700r4
Axle/Gears: Moser Rear with 4.11
Re: Need help with wiring
Sorry for the late reply, completely forgot about this post. Its carbed with an electric choke if that matters.
#5
Junior Member
Thread Starter
Join Date: Feb 2014
Location: Twin Falls, ID
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Camaro
Engine: 355 sbc
Transmission: 700r4
Axle/Gears: Moser Rear with 4.11
Re: Need help with wiring
Yeah, Im probably going to have to though. I melted yet another negative terminal. So I was thinking what about a EZwiring 21 harness? Would that work? So far EZ is the general consensus of guys from other forums that have had to basically do what Im going to do.
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
01-09-2017 04:06 PM