Removing ECM 84 Camaro
#1
Member
Thread Starter
Join Date: Mar 2011
Location: Washington state
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
Car: White 84 z28
Engine: Chevy 350
Transmission: T5
Axle/Gears: Posi and?
Removing ECM 84 Camaro
Short story is my wiring is terrible and I am redoing it simpler.
I am trying to just do what the car needs to run, leave the lights heater ect. alone because that is wired up fine as far as I know.
The engine now has an edelbrock 600 on it
What all will I need to wire, Distributer (stock hei) Alternator and starter?
Will the car run with just those hooked up, or does the computer control more than I know?
And does anyone have any tips as the where to run the wires, what gauge ones to use ect? Electronics is not my strong point so I am trying to keep it simple
I am trying to just do what the car needs to run, leave the lights heater ect. alone because that is wired up fine as far as I know.
The engine now has an edelbrock 600 on it
What all will I need to wire, Distributer (stock hei) Alternator and starter?
Will the car run with just those hooked up, or does the computer control more than I know?
And does anyone have any tips as the where to run the wires, what gauge ones to use ect? Electronics is not my strong point so I am trying to keep it simple
Thread
Thread Starter
Forum
Replies
Last Post