tried to measure voltage between fuse and ground, sparked
#1
Member
Thread Starter
Join Date: Sep 2012
Location: CA
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 RS
Engine: 305 TBI
tried to measure voltage between fuse and ground, sparked
Why would it spark at the fuse? I turned the car on, tried to measure voltage between ground on the car near door and the fuse, and it sparked. Iwas just testing that way of testing fuses
#2
Member
Join Date: Feb 2013
Location: Tampa
Posts: 346
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 IROC-Z/1980 Firebird
Engine: 5.7 TPI
Transmission: 700R4
Axle/Gears: 3.27
Re: tried to measure voltage between fuse and ground, sparked
What are you using to measure voltage? If you're using a multimeter, there are usually different terminals for the leads for voltage and current. To measure current or amps, a mulitmeter usually has a fused closed circuit inside to measure up to a specific amount (10 or 20 maybe, depending on the quality of the meter?). Make sure your leads are in the correct voltage reading terminals and try again. You don't need a closed circuit to measure a voltage potential, so you shouldn't get a spark.
Thread
Thread Starter
Forum
Replies
Last Post