Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Need Help SunPro Gauge set up

Thread Tools
 
Search this Thread
 
Old 10-21-2009, 02:45 PM
  #1  
Junior Member
Thread Starter
 
88FFCdunkel's Avatar
 
Join Date: Oct 2009
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Car: 1988 Pontiac Firebird Formula
Engine: 305 TBI
Transmission: t-5
Axle/Gears: 3.11 no/posi
Need Help SunPro Gauge set up

Where are the locations to hook up a mechanical temp gauge and a mechinical oil pressure gauge..

And also does anyone know a good location on the firewall to run the hoses? on an 88 firebird formula 305 TBI
Old 10-21-2009, 03:46 PM
  #2  
Supreme Member

 
NINÅ's Avatar
 
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes on 10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Sun Shine

The locations are the same as the electronic ones.

The oil sensor sender is located in the lower left side of the engine.

It also gives the run signal to turn on the fuel pump so you’ll have to circumvent it if you haven’t done so.

The location of the water temperature sensor varies depending on type of engine however it’s on the left.

You can probably route the tubes thru one of the grommets used for the wiring harness.


Happy Racing!



If People Drove Any Slower They’d Be Going Backwards

Fog lights are not driving lights. They look doofy. Turn em off slow pokes.

How bout those nervous nellies too scared to drive without headlights on in the daytime or if there is a little rain!

.
.

Old 10-22-2009, 10:50 AM
  #3  
Supreme Member
iTrader: (4)
 
1ADan's Avatar
 
Join Date: Mar 2009
Location: Pepperell, MA
Posts: 3,079
Likes: 0
Received 3 Likes on 3 Posts
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: Sun Shine

if you're not looking to remove any of the current sensors in the engine bay, there are a couple of other spots available.
temp - since you mentioned you have a tbi setup, you can use the spot in the driver side head for this probe. You may need an adapter depending on what came with your gauges, but it can be found at any local auto part store for $1-2
oil- i tapped off a spot right near the distributor.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
07-05-2024 11:18 PM
Frozer!!!
Camaros for Sale
35
01-19-2024 04:55 PM
colton_carlson
Firebirds for Sale
7
03-08-2019 12:21 PM
ChevyZ71
Interior
2
08-13-2015 07:30 AM



Quick Reply: Need Help SunPro Gauge set up



All times are GMT -5. The time now is 03:25 AM.