Wiring fuel boost pump
#1
Supreme Member
Thread Starter
Join Date: Mar 2005
Location: Benzie, MI
Posts: 1,665
Likes: 0
Received 3 Likes
on
3 Posts
Car: 91 rs
Engine: Blow through 383, 10 psi, xr288hr
Transmission: Manual th350 ATI 3000
Axle/Gears: 3.50 9"
Wiring fuel boost pump
Would I be able to wire my fuel booster pump for my supercharger in with the factory fuel pump at the relay? If not is there another place in the engine bay I could wire it instead of going through the firewall to the fuse panel? I also have to wire up a pump for a methanol boost cooler. Just looking for suggestions. Thanks.
#2
Supreme Member
iTrader: (3)
Join Date: Jun 2000
Location: CT
Posts: 1,680
Likes: 0
Received 2 Likes
on
2 Posts
Car: Used to drive a camaro
Batass, can I ask which booster pump your using? I can take a look at my Procharger pump and see how I wired it. My setup is piggy backed of the stock pump relay and the power wire runs up to my alternator I think. Again, I can check and get back to you. I'd think most if not all of those inline booster pumps would be wired the same.
#3
Supreme Member
Thread Starter
Join Date: Mar 2005
Location: Benzie, MI
Posts: 1,665
Likes: 0
Received 3 Likes
on
3 Posts
Car: 91 rs
Engine: Blow through 383, 10 psi, xr288hr
Transmission: Manual th350 ATI 3000
Axle/Gears: 3.50 9"
It came with the vortech. Its just a ground and power wire. If I can use the stock pump relay, can you tell me where it is?
#4
Supreme Member
iTrader: (3)
Join Date: Jun 2000
Location: CT
Posts: 1,680
Likes: 0
Received 2 Likes
on
2 Posts
Car: Used to drive a camaro
Batass, sounds a little different as mine. The pump relay should be above the rear end (assuming your on your back looking up at the car). It's mounted outside the car on the rear well wall almost centered. Now I know why I take so many digital pix of my project. I've circled the pump relay I piggybacked to.
#5
Supreme Member
Thread Starter
Join Date: Mar 2005
Location: Benzie, MI
Posts: 1,665
Likes: 0
Received 3 Likes
on
3 Posts
Car: 91 rs
Engine: Blow through 383, 10 psi, xr288hr
Transmission: Manual th350 ATI 3000
Axle/Gears: 3.50 9"
so you piggybacked the ground? Where did you hook it up exactly? Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
02-03-2019 12:21 AM