Taylor Spiro Pro Wires 8mm
#1
Supreme Member
Thread Starter
Taylor Spiro Pro Wires 8mm
K, so I bought a new set of wires yesterday. I measured all the resistance readings and one wire has 10,000ohms while all the others have between 800ohms and 1800ohms.
What is really strange (and I tried this with two different meters) is that the number begins to rise as I keep the meter attached to the wire in question. If I let go and attach again, the number will continue where it left off - if I wait a bit, the ohm reading will fall to a lower rating....but will start rising again with the meter attached. WTF!
Can anyone explain this??
What is really strange (and I tried this with two different meters) is that the number begins to rise as I keep the meter attached to the wire in question. If I let go and attach again, the number will continue where it left off - if I wait a bit, the ohm reading will fall to a lower rating....but will start rising again with the meter attached. WTF!
Can anyone explain this??
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
7
08-20-2015 09:36 PM