right (passenger) signal light wont blink
#1
Thread Starter
Member
Joined: Apr 2002
Posts: 116
Likes: 0
From: League City, Texas
Car: 92 RS - For sale
Engine: 350
Transmission: 700 R4
Axle/Gears: yup, it has a peg leg
right (passenger) signal light wont blink
ok my left signal light works fine blinks good. but my right signal light just stays on without blinking whats the problem guys look in some manual i got but all it talks about is changing the lights. what coiuld it be
#2
check your light bulbs on the side that does not work, the flasher is designed to work with a certain amount of current draw, if one or more bulbs burn out there will not be enough current draw to make the flasher work.
#4
Member
Joined: Apr 2002
Posts: 217
Likes: 0
From: fayetteville, nc
Car: 86 firebird
Engine: v6
Transmission: 7004r
right blinker
try turning on your bright for a while and then turn them off.
My car had the same problem only it was when I turned on the lights the right turn signal came on and stayed on without blinking.
I was just playing with the lights and turned on the brights for a few mintues and next thing i new the right turn signal was fixed.
psycho car I have.
My car had the same problem only it was when I turned on the lights the right turn signal came on and stayed on without blinking.
I was just playing with the lights and turned on the brights for a few mintues and next thing i new the right turn signal was fixed.
psycho car I have.
#5
Senior Member
Joined: Jun 2002
Posts: 687
Likes: 0
From: Tampa Bay, FL
Car: 85 IROC
Engine: LB9
Transmission: 700R4
Axle/Gears: 3.42
Hmm no blinkie? Ok check your bulbs first all of em light? next think to check is your grounds, especially the rear ground, all the lights in the rear ground to a screw in the body on the exterior...under the right tail light assembly...if I remember correctly..if I am wrong just trace the wires, they ground to the body somewhere...if its painted over or rusty..clean it up..a bad ground can do funky things. If that doesnt fix it...check your voltage output...I had problem with mine that was from low voltage to my lights...lights were on but no blink.
Thread
Thread Starter
Forum
Replies
Last Post