EBL: Digital Dash - 84 Vette
11-05-2006, 07:35 AM
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,432
Likes: 0
Received 227 Likes
on
212 Posts
Car: check
Engine: check
Transmission: check
Yes, the EBL ALDL stream can be the normal diag stream or the Digi-Dash stream. Need to set OptionWOrd3 bit 7: "DglDh - Enable Digital Dash ALDL stream" to enable the digi-dash stream. This bit is set with the provided EBL BIN.
If the ECM is in a diagnostic mode via 10K or shorted AB the Digi-Dash steam will revert back to the standard ALDL diag stream.
RBob.
If the ECM is in a diagnostic mode via 10K or shorted AB the Digi-Dash steam will revert back to the standard ALDL diag stream.
RBob.
11-06-2006, 08:52 PM
#3
Supreme Member
Jim,
You'll need to play with the factor in order to get it close to actual MPG. It gets a bit more complicated when using the VAFPR.
You'll need to play with the factor in order to get it close to actual MPG. It gets a bit more complicated when using the VAFPR.
09-11-2007, 10:25 AM
#5
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,432
Likes: 0
Received 227 Likes
on
212 Posts
Car: check
Engine: check
Transmission: check
Re: EBL: Digital Dash - 84 Vette
It is short for the EmBedded Lockers system. Which is a package of hardware, firmware & software for TBI & port injected engines. It uses the '86 through '95 MY series of TBI ECMs with a board added in. This board provides for high speed data logging, along with additional inputs such as WB's and pressure transducers.
A Windows program is provided for logging, display, and analysis. The ECM code (BIN file) is provided that has additional functionality and better code (the engine runs better).
The EBL Flash system does away with chip buring. There is Flash memory on board that contains the calibration data. This is updated via the Windows program via the same cable (provided) that is used to data log. It is an integrated package for engine management & tuning.
RBob.
A Windows program is provided for logging, display, and analysis. The ECM code (BIN file) is provided that has additional functionality and better code (the engine runs better).
The EBL Flash system does away with chip buring. There is Flash memory on board that contains the calibration data. This is updated via the Windows program via the same cable (provided) that is used to data log. It is an integrated package for engine management & tuning.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
Vintageracer
Interior Parts for Sale
12
09-24-2017 12:34 PM
