quick IAC question
#2
Moderator
Join Date: Feb 2000
Location: Schererville , IN
Posts: 7,015
Likes: 0
Received 1 Like
on
1 Post
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
fully extended the greater the counts the farther open the air bleed is and the less counts the less adjusting the iac is doing..
Search on IAC , there is alot of good info here, just be prepared for some work to tame it down if u have a rowdy combo :-)
later
Jeremy
Search on IAC , there is alot of good info here, just be prepared for some work to tame it down if u have a rowdy combo :-)
later
Jeremy
#3
Junior Member
Thread Starter
Join Date: Dec 2001
Location: NC
Posts: 83
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 Trans Am
Engine: 350 TPI
Transmission: 700R-4
been at battle with trying to get the idle as smooth as possible lately and being the dumbass that i am, thought that 160 steps was fully closed. now that i read my scantool book and your reply have relized i was adjusting in the wrong direction.
thanks. should be smooth as glass in a few minutes.
thanks. should be smooth as glass in a few minutes.
#5
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,432
Likes: 0
Received 225 Likes
on
211 Posts
Car: check
Engine: check
Transmission: check
Originally posted by Ronny
any reason the iac in my car reads 60 steps at cruise speeds(70mph). CL and 185 deg on temp. i would think at 0 steps above conditions.
at idle CL reads zero and appears steady at zero(AC off).
is iac position affected by tps or map?
any reason the iac in my car reads 60 steps at cruise speeds(70mph). CL and 185 deg on temp. i would think at 0 steps above conditions.
at idle CL reads zero and appears steady at zero(AC off).
is iac position affected by tps or map?
RBob.
Thread
Thread Starter
Forum
Replies
Last Post