using excel/diacom to adjust VE tables
#1
Member
Thread Starter
Join Date: Jul 2000
Location: Fort Myers,FL
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
using excel/diacom to adjust VE tables
Guys just going to trow this out there. This may have been mentioned .
Just thinking some.
Can one use the excel diacom file and then enter your specific VE table then have excel compare and recalculate the INT and display the new VE.
I know diacom will be specific on map tables eg. 45,64,47 kpa where as tuner/gmpro go every 10. eg. 10,20,30,40.......kpa
so maybe set excel to read 35-45,45-55,55-65.......kpa
the diacom eg. could be
55kpa@2500rpm,int=116
excel would be
((INT – 128) x .2) = Change to VE table value.(per glen91gta)
(116-128) x .2)=2.4 so have in the next colums your actual VE table typed in and then it will spit out all the VE changes.
actual VE 54--->new ve should be 51.6
This is just a idea very rough thinking here.
Dennis
http://bowtye8.tzo.com
Just thinking some.
Can one use the excel diacom file and then enter your specific VE table then have excel compare and recalculate the INT and display the new VE.
I know diacom will be specific on map tables eg. 45,64,47 kpa where as tuner/gmpro go every 10. eg. 10,20,30,40.......kpa
so maybe set excel to read 35-45,45-55,55-65.......kpa
the diacom eg. could be
55kpa@2500rpm,int=116
excel would be
((INT – 128) x .2) = Change to VE table value.(per glen91gta)
(116-128) x .2)=2.4 so have in the next colums your actual VE table typed in and then it will spit out all the VE changes.
actual VE 54--->new ve should be 51.6
This is just a idea very rough thinking here.
Dennis
http://bowtye8.tzo.com
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
7
10-08-2015 08:34 PM