RamJet computer tuning (MEFI ECM)
#1
Member
Thread Starter
Join Date: Aug 2010
Location: Kansas City
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 TA - 17k orig miles
Engine: 355
Transmission: 700R4
Axle/Gears: 3.44 Dana 44 performance rear
RamJet computer tuning (MEFI ECM)
I picked up an MEFI computer and harness setup that from what I found is from a 2004 RamJet 502 engine - I've got a carb'd 350 that I was thinking about retrofitting EFI onto and thought this might be a quick way to get going.... Unfortunately I've found very little tuning Info for this computer and was wondering if anyone had any links to the hardware / software that could be used for tuning this.
Otherwise - anyone know what this stuff is worth - might have to re-sell it if I can't get the stuff to tune it and run it on a 350...
EDIT - I believe it is an MEFI 4 controller #12569494 - will verify the P/N tomorrow afternoon when I go back out to the garage and pull it out of the box again
Otherwise - anyone know what this stuff is worth - might have to re-sell it if I can't get the stuff to tune it and run it on a 350...
EDIT - I believe it is an MEFI 4 controller #12569494 - will verify the P/N tomorrow afternoon when I go back out to the garage and pull it out of the box again
Last edited by bwiencek; 04-19-2013 at 09:35 PM.
#2
Re: RamJet computer tuning (MEFI ECM)
You don't state what version you have hopefully 4 not worth fooling with IMO.
http://www.obd2allinone.com/sc/toplevel.asp?cat=32
http://www.obd2allinone.com/sc/toplevel.asp?cat=32
#3
Member
Thread Starter
Join Date: Aug 2010
Location: Kansas City
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 TA - 17k orig miles
Engine: 355
Transmission: 700R4
Axle/Gears: 3.44 Dana 44 performance rear
Re: RamJet computer tuning (MEFI ECM)
I believe it's an MEFI 4 version as I think I looked that page up when I was at the swapmeet and saw that it was the later model.
Thread
Thread Starter
Forum
Replies
Last Post