Rockford Fosgate Punch Stage 2
12-17-2004, 09:07 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2003
Location: rotterdam ny
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Rockford Fosgate Punch Stage 2
what would be a good amp under a $100 to power one 12" Rockford Fosgate Punch Stage 2 sub that is 200 watss rms and 400 watts peak .any suggestions will be much appreciated thanks.
what do u think of this?
http://cgi.ebay.com/ws/eBayISAPI.dll...ayphotohosting
what do u think of this?
http://cgi.ebay.com/ws/eBayISAPI.dll...ayphotohosting
Last edited by jpang115; 12-17-2004 at 09:12 PM.
12-18-2004, 12:48 PM
#3
Junior Member
Join Date: Jan 2004
Location: El Paso, TX
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Camaro RS
Engine: V8 305
i think that sony would be a waste of money imho. what voice configuration are u getting with those rockford's? Look at this amp, very solid and underated like most ppi stuff. http://www.ikesound.com/product-product_id/1816
12-18-2004, 03:45 PM
#5
Junior Member
Join Date: Jan 2004
Location: El Paso, TX
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Camaro RS
Engine: V8 305
ok, it would be best to get the P212S4 thats the single voice coil 4-ohm version. Wire it like in this diagram http://jlaudio.com/tutorials/wiring/index.html#1svc So that leaves u at 4-ohm's bridged mono. Since the PPI amps are underated, i would suggest u be careful with the gain.
Thread
Thread Starter
Forum
Replies
Last Post
