Repaired Headliner Pics
#1
Repaired Headliner Pics
What do you guys think? I re-did the headliner and sail panels.....I think they came out kick ***! Gonne mount em back in tomorrow hopefully.
Here's some before and after pics...the before ones sort of suck...but you can see the damage.
Here's some before and after pics...the before ones sort of suck...but you can see the damage.
#3
It's actually quite a bit stiffer. I tried to go pretty light on the fiberglass for fear that it may affect the fit of the headliner if I laid it on too thick. Overall I'd say I got @ 50% stiffer than when I took it out. No bending in the middle now....but the ends still bend if forced ;-)
I started out just using glue and fiberglass cloth (like an article I read suggested), and then someone here said resin would be fine so I changed paths mid-stream ;-)
So far I'm loving the result!
I started out just using glue and fiberglass cloth (like an article I read suggested), and then someone here said resin would be fine so I changed paths mid-stream ;-)
So far I'm loving the result!
#4
Member
Joined: Feb 2001
Posts: 133
Likes: 0
From: Worcester, MA
Car: 1991 GTA
Engine: 305
Transmission: 700R4
Looks good Moto..
I used one of those kits from NextGen, which turned out OK, but could have been better. ALthough they said the board was split in two and the fabric was one piece, both the fabric and board came in two pieces so now i have a little gap where the two pieces meet, right under my center dome light.
But yours looks great!
I used one of those kits from NextGen, which turned out OK, but could have been better. ALthough they said the board was split in two and the fabric was one piece, both the fabric and board came in two pieces so now i have a little gap where the two pieces meet, right under my center dome light.
But yours looks great!
Last edited by Apone; 01-09-2002 at 08:35 AM.
Thread
Thread Starter
Forum
Replies
Last Post