180 Speedo for Firebirds
#51
Moderator
Thread Starter
Join Date: Mar 2001
Location: Doghouse ······································ Car: 1989 Formula 350 Vert Engine: 350 L98 Transmission: 700R4 Axle/Gears: B&W 3.27
Posts: 14,242
Received 170 Likes
on
125 Posts
Car: 87 Formula T-Top, 87 Formula HT
Engine: 5.1L TPI, 5.0L TPI
Transmission: 700R4, M5
Axle/Gears: Sag 3.73, B&W 3.45
The dimentions of the original Speedo is (4 9/16" wide x 4 1/4" tall)that is the gage size NOT the image size because the Image might have a little white around the edges. The circle should be about (4 5/32" in DIA)
To resize the 180 speedo image to about perfect you have to resize the image to 42% of the original size
The 100 AND 150 Speedo I had to resize twice 44% was too big, 43% was too small. So resize to 44% then resize again to 99% to get it perfect.
Keep in mind that you take your original gage and lay it on top of your print, then you can see how well the holes line up to your original. I Traced the outside of the original on the computer, so you have to go from the INSIDE of the line.
HOPE that makes sence...
John
[This message has been edited by okfoz (edited November 21, 2001).]
To resize the 180 speedo image to about perfect you have to resize the image to 42% of the original size
The 100 AND 150 Speedo I had to resize twice 44% was too big, 43% was too small. So resize to 44% then resize again to 99% to get it perfect.
Keep in mind that you take your original gage and lay it on top of your print, then you can see how well the holes line up to your original. I Traced the outside of the original on the computer, so you have to go from the INSIDE of the line.
HOPE that makes sence...
John
[This message has been edited by okfoz (edited November 21, 2001).]
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Interior Parts for Sale
0
08-24-2015 06:54 AM
beachrodder
Transmissions and Drivetrain
3
08-07-2015 04:27 PM