Hood differences 85-92 IROC/Z28
#1
Thread Starter
Member
iTrader: (2)
Joined: Aug 2012
Posts: 418
Likes: 1
From: Lascassas TN
Car: 1989 IROC G92 LB9 MK6
Engine: LB9
Transmission: MK6
Axle/Gears: 3.45
Hood differences 85-92 IROC/Z28
Any difference in IROC/Z28 hoods from 1985-92? I know the vents vs. blisters are not the same, I am asking if the base metal hood is the same for these years?
#3
Junior Member
iTrader: (3)
Joined: Nov 2010
Posts: 95
Likes: 0
From: Midlothian, VA
Car: 86 ASC Convertible #90
Re: Hood differences 85-92 IROC/Z28
All hoods are not the same. I don't want to give the wrong year change but somewhere around 89-90 there was a difference. Maybe someone will chime in?
#4
Member
Joined: May 2007
Posts: 342
Likes: 0
From: Vancouver, B.C
Car: 91 RS TBI 91 Z28 TPI
Engine: 305
Transmission: wc T5
Re: Hood differences 85-92 IROC/Z28
if the hood came from the factory with blisters or came with louvers, the hoods will be the same. blisters and lovers are interchangeable.
flat hoods don't sit right on tpi cars the plastic intake gets in the way a bit..... at least that's what happened when i tried it
flat hoods don't sit right on tpi cars the plastic intake gets in the way a bit..... at least that's what happened when i tried it
Last edited by sid rs91; 09-25-2012 at 09:59 PM.
#5
Re: Hood differences 85-92 IROC/Z28
Flat hoods work fine on all models. The B4C cars were used a flat hood and had TPI so that should change your thinking. Plus the underside of the hood is the same for the RS and the Z. The louvered/blistered hoods do not sit any higher than the RS hoods, they are the same shape.
All IROC-Z/Z28 hoods from 1985-1992 are the same exact hood.
All IROC-Z/Z28 hoods from 1985-1992 are the same exact hood.
#6
Thread Starter
Member
iTrader: (2)
Joined: Aug 2012
Posts: 418
Likes: 1
From: Lascassas TN
Car: 1989 IROC G92 LB9 MK6
Engine: LB9
Transmission: MK6
Axle/Gears: 3.45
Re: Hood differences 85-92 IROC/Z28
Thank you, my hood was victimized by a hood pin installer, it will be the only non original body panel on my car since it must be replaced. Thanks.
#7
Senior Member
iTrader: (4)
Joined: Jan 2008
Posts: 545
Likes: 0
From: Rustfree Gilbert Arizona
Car: 1989 IROC
Engine: 305TPI
Transmission: 700R4
Axle/Gears: 2:73 posi
Re: Hood differences 85-92 IROC/Z28
I have '85 and '89 Z/28s and there is definitely a big difference in the hoods. The '89s hood is better because it is much sharper in the front and fits better on both cars. The '85s hood is very blunt (almost fat) on the leading edge and doesn't seem to have good factory tolerances. I could barely bolt the '85s to the '89 because the front latch couldn't reach and it left a gap between the leading edge and front bumper...
Thread
Thread Starter
Forum
Replies
Last Post
Black89TA
Exterior Parts for Sale
9
07-23-2016 10:42 AM
3rdgenparts
Firebirds for Sale
0
08-06-2015 09:03 AM