Is there a kit to do this mod?
#2
Supreme Member
iTrader: (8)
Joined: Dec 2005
Posts: 2,412
Likes: 14
From: Northern CT
Car: 1986 Trans am
Engine: 5.3 LM7
Transmission: T56 6 speed
Axle/Gears: Dana 44 w/ 3.55's
Re: Is there a kit to do this mod?
Yea, just buy a firebird!
Never seen it before. I personally don't really care for the looks but it's not the worst one I've seen.
Never seen it before. I personally don't really care for the looks but it's not the worst one I've seen.
#4
Supreme Member
iTrader: (8)
Joined: Jul 2001
Posts: 3,204
Likes: 6
From: New Boston, IL, USA
Car: '90 Formula 350
Engine: 383 SBC
Transmission: ProBuilt S/S 700-R4 & ACT 9" Stall
Axle/Gears: 10 bolt 3.23
Re: Is there a kit to do this mod?
Fenders and quarter panels kinda look like a wide body kit, but the lines don't look exactly like that.
From that picture it almost looks like the nose and the fenders are one piece I can't see a seam on them.
From that picture it almost looks like the nose and the fenders are one piece I can't see a seam on them.
#5
Supreme Member
iTrader: (1)
Joined: May 2003
Posts: 2,023
Likes: 3
From: Evansville, IN
Car: 1992 Camaro RS 25th Anniversary
Engine: 3.4L v6 with a t3/t4 Turbo
Transmission: T-5 Conversion
Axle/Gears: 3.23 SLP Limited Slip
Re: Is there a kit to do this mod?
looks identical to a concept car that is in the new issue of camaro performers...didnt think it was an actual car though
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
1
01-15-2016 06:26 AM
1Aauto
Sponsored Vendors
0
09-02-2015 01:35 PM