bent radiator support
#1
Junior Member
Thread Starter
Join Date: May 2010
Location: Saginaw Mi
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Camaro z28
Engine: 350 small block
Transmission: 350 Turbo
bent radiator support
so i was pulling my z28 out some soft mud with my blazer and i hook up my towing strap up to what i thought was a towing pont but was my radiator support it was the center hole and it bent in it didnt damage anything but im not sure how to fix this try to bent it back out or cut and weld
what you guys think?
what you guys think?
#2
Supreme Member
iTrader: (15)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,666
Likes: 0
Received 50 Likes
on
48 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: bent radiator support
how bad? pic? if its not hurting anything, leave it alone. Maybe try to beat/pull it back to shape.
#3
Supreme Member
iTrader: (8)
Join Date: Aug 2003
Location: LeRoy, NY
Posts: 7,240
Likes: 0
Received 6 Likes
on
5 Posts
Car: 2003 Hyundai Tiburon GT
Engine: 2.7L V6
Transmission: 6-speed
Axle/Gears: 4.41
Re: bent radiator support
Remove the condenser and radiator and beat it back into shape with a hammer, supported underneath by a jack and a 2x4. If screwed up enough, your electric coolant fan won't work and you could overheat, among other problems. I just straightened mine this way (it's not a jack point, either). FYI, the towing points are in front of each front wheel, what looks like a loop in the area of where the sway bar connects to the body.
Thread
Thread Starter
Forum
Replies
Last Post
91TTOPZ
Exterior Parts for Sale
5
09-20-2016 12:42 PM