AERO WING MOUNTS
#1
Thread Starter
Junior Member
Joined: Mar 2008
Posts: 23
Likes: 0
From: West Hartford, Connecticut
Car: 1988 Pontiac Trans Am GTA
Engine: 5.0 :( wanna go bigger
AERO WING MOUNTS
Hey guys, Im gonna be selling my Fiberglass Aero Wing (not sure who made it, came w/ the car) It was never really installed 100% the factory mounts are there but weren't used, around the hatch trim. My question is this, those mounts look like they are welded onto the metal trim? Or are the just pushed in? They have a small circle visible when you look at the inside of the hatch, but no beads around the outside... Im selling the wing and would like to inclue these, or just remove them for the louvers I have... How hard will it be to remove cleanly is where Im going with this... Should I just get a whole nother hatch? The new wing is a fiberglass hi rise style so Im gonna be drilling new holes anyways... please share thanks alot.
#2
Joined: Aug 2006
Posts: 12,667
Likes: 50
From: Central NJ
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: AERO WING MOUNTS
the clips are welded on. I dont think there is a way to remove them from the hatch without destroying the hatch in the process. I removed mine and had to grind them off
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:49 AM