pins only?
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Sep 2005
Location: Highwood, IL
Posts: 743
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1983 trans am
Engine: Vortec 350 w/ a comp cam
Transmission: B&Mth350 2800holeshot
Axle/Gears: 10bolt 3.23's
pins only?
can u run only hood pins without the stock latch? i though of a cool intake idea but the hood latch is in the way. just curious
#2
Supreme Member
Join Date: Nov 2004
Location: Connecticut
Posts: 1,345
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
yes you can. i dont have a latch on mine and it works fine.
#3
Supreme Member
same here on my 82 Z28, all latch parts removed, just two pins hold it down, works great no problems at all
might be able to see them in my pic link url in my signature
click on the word Z-28, its blue or red depending on if you have ever clicked it before or not
im soon going to scrap that hood and put a flat 87 base hood on it that i have laying around that i was gonna scrap, the purple hood is going to scrap, and that big plastic thingy on it too, i dont like it
il have to drill holes and stuff again, but im going to relocate the pins so they are not so close to the fenders and make then line up with the headlights- more out in the open area of the hood corners
the only reaosn they are so far out into the corners right now is because the PO that installed them was too lazy to extend the rad support out with some pieces of metal
if you have any Q's then ask me
good luck
might be able to see them in my pic link url in my signature
click on the word Z-28, its blue or red depending on if you have ever clicked it before or not
im soon going to scrap that hood and put a flat 87 base hood on it that i have laying around that i was gonna scrap, the purple hood is going to scrap, and that big plastic thingy on it too, i dont like it
il have to drill holes and stuff again, but im going to relocate the pins so they are not so close to the fenders and make then line up with the headlights- more out in the open area of the hood corners
the only reaosn they are so far out into the corners right now is because the PO that installed them was too lazy to extend the rad support out with some pieces of metal
if you have any Q's then ask me
good luck
Last edited by Randy82WS7; 12-02-2005 at 11:35 AM.
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
3
09-17-2015 03:38 PM
gta892000
Cooling
6
09-16-2015 12:37 AM