will a high rise wing line up on my trans am???
03-21-2005, 05:51 AM
#1
Banned
Thread Starter
Join Date: Dec 2004
Location: Cape Cod, MA
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1998 eclipse GSX
Engine: 4G63 2.0
Transmission: 5 speed
will a high rise wing line up on my trans am???
will the high rise wing fit on my 88 trans am??? I noticed they say it only fits a camaro but last i checked, trans am and camaro had the same rear end - hatch, rear qtr panels, etc. I understand i would have to probably make new holes and all but does this wing line up??? Has anyone done it before??? Pics???
03-21-2005, 08:21 AM
#2
Supreme Member
iTrader: (2)
Join Date: Dec 2000
Location: Buffalo, NY
Posts: 2,361
Likes: 0
Received 2 Likes
on
1 Post
Car: 1984 Trans Am
Engine: LT1
Transmission: T56
Axle/Gears: 10 bolt w/ 4.10 gears
it's been done several times on this board. The deck lid is identical on Camaros and Firebirds. The rear quarters are a little different though. The firebird's quater panels stick out further so the rear end is a bit wider. This means the bottom corners of the high-rise spoiler will be set in about 1" from the edge of the quarter panels... here, a picture is worth 1000 words:
03-21-2005, 11:40 AM
#3
Supreme Member
Join Date: Jan 2005
Location: Amsterdam , NY
Posts: 1,699
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1985 Trans Am
Engine: vee eight
Transmission: auto
Axle/Gears: 4.10 gears
the bolt holes arent going to line up , you will have to drill new ones. So take that into account .
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM
