Z28 Nose piece, replacing SC nose...
#1
Member
Thread Starter
Join Date: Dec 2003
Location: VA, USA
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Car: '84 Camaro SC/ I-ROC Body Conversio
Engine: Rebuilt 350 5.7L, Edelbrock 750cfm
Transmission: Re-built 700-R4
Axle/Gears: Moser, 3.73
Z28 Nose piece, replacing SC nose...
Can someone post a fairly sharp pic of how the plastic front lower spoiler for the Z28/I-ROC is bolted on the the bottom of the fender where that little rounded lip is? It looks like it would connect in 3 places but i don't know how to go about connecting it together so that it won't come loose over time and so it doesn't look like some slap-happy joe blow put it together. No one sees this inner part but i'll know and it would peeve me to no end in the end if it didn't look right. Thanks
#2
I know that you asked for a pic but I don't have one, so I'll explain it as best I can tomorrow morning after I look at mine (unless someone actually has a picture of this). I've taken my entire front clip off, but I don't recall exactly how everything came apart because I haven't looked at it in a few weeks.
I may also have an exploded view of this from a Camaro parts catalog that I have on CD
- 89_IROC
I may also have an exploded view of this from a Camaro parts catalog that I have on CD
- 89_IROC
#3
Member
Thread Starter
Join Date: Dec 2003
Location: VA, USA
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Car: '84 Camaro SC/ I-ROC Body Conversio
Engine: Rebuilt 350 5.7L, Edelbrock 750cfm
Transmission: Re-built 700-R4
Axle/Gears: Moser, 3.73
The exploded view would probably help even more than a real picture. Post it for me if you can. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post