Replacing Light Switch Knob (92 RS)
#1
Senior Member
Thread Starter
Join Date: May 2003
Location: Bath, Maine
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro RS Convertible & 1983 P
Engine: 305 TBI & 305 4 BBL & 4.7 liter
Transmission: Auto & Auto & 5 Speed Manual
Replacing Light Switch **** (92 RS)
Hi,
I have a '92 RS convertible, a worn light switch **** (the image is rubbed off), and a new light switch **** (probably the last one in the GM parts inventory, which I had to order from a dealership in California..... and I live in Maine!).
Question is this: How to replace the **** and how to get it done? I think I remember from my '68 GTO, that there was a detent on the back of the light switch, that if you depressed it, you could pull the whole **** and shaft right out of the light switch. Is this the same way?
What is the easiest, least destructive way to accomplish this?
In advance ......... THANKS!!!
Steve
I have a '92 RS convertible, a worn light switch **** (the image is rubbed off), and a new light switch **** (probably the last one in the GM parts inventory, which I had to order from a dealership in California..... and I live in Maine!).
Question is this: How to replace the **** and how to get it done? I think I remember from my '68 GTO, that there was a detent on the back of the light switch, that if you depressed it, you could pull the whole **** and shaft right out of the light switch. Is this the same way?
What is the easiest, least destructive way to accomplish this?
In advance ......... THANKS!!!
Steve
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
07-05-2024 11:18 PM
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM