Column pull
#1
Supreme Member
Thread Starter
Join Date: Dec 1999
Location: Calgary
Posts: 1,934
Likes: 0
Received 1 Like
on
1 Post
Car: 89 Formula
Engine: 350
Transmission: TH 700R4
Axle/Gears: 3.27
Column pull
Bought a theft recovery, 87 Trans Am--am slowly starting to get it up and running (better) So today I tried to swap out a column (since mine is all smashed to hell)
today from an 84 Trans Am--to an 87. Got it out--got mine out but having a heck of a time getting it back in.
The two shafts don't want to mate together--wehn I can a bolt goes through to keep together.
Eventaully we took the shaft off the steering box--pulled the column out and tried to put'em together--still no fit!
Finally, my buddy took both pieces back to his house where here ground off enough metal to make them fit. Tomorrow is round 2!
Anyone ever do this? any tips?
today from an 84 Trans Am--to an 87. Got it out--got mine out but having a heck of a time getting it back in.
The two shafts don't want to mate together--wehn I can a bolt goes through to keep together.
Eventaully we took the shaft off the steering box--pulled the column out and tried to put'em together--still no fit!
Finally, my buddy took both pieces back to his house where here ground off enough metal to make them fit. Tomorrow is round 2!
Anyone ever do this? any tips?
Thread
Thread Starter
Forum
Replies
Last Post