HELP with new H4 Headlights!
#1
Supreme Member
Thread Starter
Join Date: May 2002
Location: Oklahoma
Posts: 1,019
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro Z28
Engine: L98 5.7 V8 TPI
Transmission: 700R4
HELP with new H4 Headlights! PLZ!!!
Ok i just got my new diamond cut headlights wiht H4 bulbs, I installed them and turned them on to see how they look, and when i did, the high beams came on to. I flipped the turn signal thing to turn them off, but that just made them brighter, So when i turn on the low beams the high beams come on too?? Can anyone help me with this? Thanks Alot.
Last edited by Quick6; 06-24-2002 at 01:38 PM.
#4
You don't need to cut anything, you can simply pull the pins out of the connector and insert them into the proper position.
But your problem is that H4s use the same connector, but the pins do different things.
But your problem is that H4s use the same connector, but the pins do different things.
#6
Supreme Member
Thread Starter
Join Date: May 2002
Location: Oklahoma
Posts: 1,019
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro Z28
Engine: L98 5.7 V8 TPI
Transmission: 700R4
Ok I got it working and they look great. What Jza suggested worked great and was not to hard. Thanks for all your help.
#7
Originally posted by Blackened
Pulling the pins out of the connectors is not a simple as you make it sound. I'd rather cut two wires and reconnect them with buttconnectors. Much easier....
Pulling the pins out of the connectors is not a simple as you make it sound. I'd rather cut two wires and reconnect them with buttconnectors. Much easier....
Trending Topics
#9
H4's (and similar) are the little bulbs that plug into the plastic headlight housings in most newer vehicles (usually imports). "H4" is just the part number of the bulb, like "H4656" is the number for the bulb used in Camaros.
Thread
Thread Starter
Forum
Replies
Last Post