Opening dash vents
#1
Senior Member
Thread Starter
Join Date: Jun 2002
Location: Tampa Bay, FL
Posts: 687
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 IROC
Engine: LB9
Transmission: 700R4
Axle/Gears: 3.42
Opening dash vents
I posted this in the cooling forum too. hmmm this is probably a better place.
OK My IROC has factory air, but the only vents are the center ones...the others at each side of the dash are blocked off...wtf that is about I have no clue. Anyway, when I put my hand over the blocked panels...they feel cold...so it seems like all I need to do is cut out the dash and install the vent heads...anyone ever do this? let me know before I screw up my dash.
OK My IROC has factory air, but the only vents are the center ones...the others at each side of the dash are blocked off...wtf that is about I have no clue. Anyway, when I put my hand over the blocked panels...they feel cold...so it seems like all I need to do is cut out the dash and install the vent heads...anyone ever do this? let me know before I screw up my dash.
Thread
Thread Starter
Forum
Replies
Last Post