I just bought a set of 4thgen seats and the driver side is power. I have got to get these seats in by Sunday but I dont know where to hook up the seat to give it power.

Anyone done this? Or know where is a safe place to tie into? Also, is there a minimum gauge wire I should use? The connecter on the seat looks like pretty heavy wire.

Thanks!

 

Look on the driver's side kick panel, above the hood release assembly. There's a terminal board with battery and ignition you can plug into. Use #12 wire or larger.

 

RB83L69, thanks for the reply. Im bad at electronics and wiring stuff. Heres a pic of that area under my dash:

http://www15.brinkster.com/bfspace/c...ngmess-big.jpg

the terminal board your talking about, is it the fuse thing or the one on the wall behind it?

There is a connecor right in the middle of that pic with a green and purple wire going into it, any idea what its for? It wouldnt by chance be hot and ground would it?

And Im told that the wires hanging all over the place came from an alarm. You can only see maybe 5 out of the 25+ wires under there that are serving no usefull purpose.