how do u take off gfx on 91 fbird door?
#1
Member
Thread Starter
iTrader: (1)
Join Date: Oct 2001
Location: Bergen County, NJ
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Firebird GTA
how do u take off gfx on 91 fbird door?
i have a body kit in ready to be installed except when i was looking at the gfx on the door-i couldn't find any way of removing them-anyone know how do do this???
one more thing-the side gfx (under the door) to take those off they get unscrewed by the wheel wells and under the door right?
thanks
one more thing-the side gfx (under the door) to take those off they get unscrewed by the wheel wells and under the door right?
thanks
#2
Supreme Member
Join Date: Jul 2000
Location: Tomball, TX
Posts: 1,787
Likes: 0
Received 20 Likes
on
16 Posts
Car: 89 TTA
Engine: Turbo 3.8
Transmission: 200R4
To remove the "under the door" gfx, you just need to remove all the screws on the bottom of the car holding it on along with the ones in the wheel wells, then take them off the bracket that is holding them. The bracket is on the rear of the front fender and appeared to be riveted to the fender if I remember correctly. I tried everything to get the gfx out from that bracket but the gfx eventually tore in that little spot. While I haven't taken the door ones off yet, I believe you have to remove the door panels and get them from inside the door.
#3
Supreme Member
iTrader: (1)
Join Date: Mar 2001
Location: Cherry Hill, NJ
Posts: 2,181
Likes: 0
Received 1 Like
on
1 Post
Car: 92 Trans Am 'Vert
Engine: 305 TPI
Transmission: 5 Speed
You need to put the window up, remove the door panel, and youll see all the bolts. The under door ones are no problem. Unscrew the screws in the door jamb, un bolt the bolts in the fenderwells, and under the car, and itll slide right off.
Thread
Thread Starter
Forum
Replies
Last Post